DIY washer repair | Washer troubleshooting

November 7, 2019 by No Comments

Utilize since quite a while ago nosed pincers to push them into position so as to abstain from breaking the wire associations – never pull a wire by hand.

Unplug the washer. To get to the clock,https://24happliancerepair.com evacuate the control handles and the board that covers the controls. This is normally a similar control board we talked about before, however may likewise be gotten to be through a board at the back of the unit. Cautiously look at the wires that associate the clock to different pieces of the washer.

On the off chance that the wires are free or disengaged, take a stab at pushing them into position; they typically fit into their terminals like attachments. Utilize since quite a while ago nosed pincers to push them into position so as to abstain from breaking the wire associations – never pull a wire by hand.

To test the clock, utilize a volt/ohm meter (VOM) set to the RX1 scale. The RX1 scale is the least and ought to be the default setting of the meter. Separate the power prompts the clock and clasp one test of the VOM to each lead. The VOM should understand zero if the clock is working.

Since the clock is a multipurpose switch, turn it through its cycle and test each pair of terminals thus. The meter should peruse zero at all of these focuses. On the off chance that at least one readings are over zero, the clock is broken and ought to be supplanted.

To supplant the clock, unscrew and separate the former one. Introduce another clock made explicitly for the clothes washer. Disengage the old wires each in turn, interfacing each relating new wire as you work to ensure the associations are appropriately made. After every one of the wires are associated, check the associations again for accuracy and screw the clock get together into the right spot.

Leave a Comment

Your email address will not be published. Required fields are marked *